Häfele HDW-FI60D, Руководство пользователя

Страница: 14 / 64

EN11
4.9. Filling the detergent
4.11. Rinse-aid usage
4.12. Filling the rinse-aid and
setting
4.10. Using combined detergents
Do not fill detergent into the detergent
compartment more than required;
otherwise you can see whitish streaks
or bluish layers on glass and dishes and
may cause glass corrosion. Continued
use of too much detergent may cause
machine damage.
Using little detergent can result in poor
cleaning and you can see whitish
streaksin hard water. See the detergent
manufacturer’s instructions for a further
information
Push the latch to open the dispenser
and pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled
just before the start of each programme.
If the dishes are heavily soiled, place
additional detergent in the pre-wash
detergent chamber.
The rinse aid helps to dry the dishes
without streaks and stains. Rinse-aid is
required for stain-free utensils and clear
glasses. The rinse aid is automatically re-
leased during the hot rinse phase. If rinse
aid dosage setting set too low, whitish
stains remains on dishes and dishes do
not dry and washed clean. If rinse aid
dosage setting set too height, you can
see bluish layers on glass and dishes.
These products should be usedaccording
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the
combination. We recommend you do
not use combined detergents in short
programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact
the detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level
Detergent
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill
the
compartment with rinse aid to the
MAX level and then close the cap.
Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid
level, follow the below steps:
Open the door of the machine.
Turn on the machine, and touch
the Programme button as soon as the
machine is turned on.
Hold down the Programme
button until “rA” disappears. Rinse aid
setting follows water hardness setting.
The machine will display the last
setting.
Change the level by touching
the programme button.
Turn off the machine to save
the setting. The factory rinse aid level
setting is “4”.
If the dishes are not drying properly or
are spotted, increase the level. If blue
stains form on your dishes, decrease
the level.