Hafco MetalMaster BS-5S, Руководство по эксплуатации

Страница: 14 / 27

14
OPERATION MANUAL
5.2 SETTING THE CUTTING ANGLE
The band saw is fitted with the capacity to cut angles
with the head being able to be swiveled up to 45° to
the right. (Fig. 5.3) To set the angle of the cut, raise the
bow saw to the highest point and hold with the head
lock.
Loosen the swivel lock lever (Fig. 5.4) and rotate the
head until the scale (Fig. 5.4) is at the angle required.
Tighten the swivel lock lever to keep the head in
place.
NOTE: Please note that the scale (Fig.5.4) is for
reference only and if the angle is required to be very
accurate then the angle should be checked with a
protractor after the cut.
5.3 VERTICAL OPERATION
The Model BS-5S can easily be set up for vertical
cutting operations to make cuts that are not a straight
cut through the entire workpiece, such as curves or
pattern cuts. To assemble the band saw for vertical
cutting:
1. DISCONNECT THE BAND SAW FROM THE POWER!
2. Remove the two flat head screws and the blade
guide cover shown in Fig. 5.5.
3. Install the table and replace the two screws
removed in Step 2.
F
ig
. 5.3
s
wiveL
L
ocK
F
ig
. 5.4
F
ig
. 5.5