Hafco B003, Руководство по эксплуатации

Страница: 12 / 27

12
OPERATION MANUAL
4.5 ASSEMBLY
The machine must be fully assembled before it can be
operated. First clean any parts that are coated in rust
preventative to ensure the assembly process can pro-
ceed smoothly. Although the main components of the
Hafco Metalmaster BS-5S are assembled at the factory,
some assembly is required.
1. Assemble the stand using the M8 x 10mm bolts,
8mm flat and spring washers. (Fig. 4.1)
Note: At this time, tighten with a 14mm wrench
or socket just enough to secure the parts. Final
tightening will take place when the band saw has
been added to the stand.
2. Place the band saw on the stand, and secure it
to the stand using a M8 x 50 mm stud and nut at
the middle of the vice end and a M8 x 100 mm
in the middle of the motor end. (Fig. 4.2)
3. Check to see if band saw is relatively level, then
tighten all bolts and nuts.
4. Install the length stop shaft into side of band
saw, then lock it in place by using a Hex key to
tightening the set screw. (Fig. 4.3)
F
ig
. 4.1
4.6 TEST RUN
Once assembly is complete, test run the machine to ensure it is properly connected to the
power and that the guards and safety components are functioning properly.
If you find an unusual problem during the test run, immediately stop the machine, disconnect it
from the power, and fix the problem BEFORE operating the machine again.
The Troubleshooting table in the Maintenance section of this manual can help.
If no answer can be found contact your local distributer and report the fault.
Serious injury or death can result from using this machine BEFORE
understanding its controls and related safety information. DO NOT operate, or allow others to
operate, machine until the information is understood.
H
ex
K
ey
F
ig
. 4.3
F
ig
. 4.2