Hafco Woodmaster BP-480, Инструкция по эксплуатации

Страница: 9 / 32

5. OPERATING INSTRUCTION
LIFTING AND PLACING
On the day that the machine arrives, make sure that a
crane or forklift with sufficient capacity is available to
unload the machine from the vehicle.
Ensure access to the chosen site is clear and that doors
and ceilings are sufficiently high and wide enough to
receive the machine.
1. Move the crate to the chosen location, then
remove the crate from the base
2. Unbolt the bandsaw from the pallet
3. Use the eye bolt supplied with the machine to
attach a certified lifting sling or hook (Refer Fig. 1).
4. Slowly lift the machine off the pallet and
carefully place it into position.
5. Once machine is set in place it is
recommended to level the machine and bolt it in place.
ASSEMBLING
1. Attach the hand wheel (see Figure 2) to the
machine.
2. Slide the table slot to the saw blade and slowly
move to the center of the table. Adjust the table
until the saw blade is in the center of table insert.
3. Install table insert. Then, install table gap screw
assembly, secure with (1) M8 nut, (2) M8 flat
washer and tighten gap screw. (see Figure 3)
4. Make sure the table is in the center. Then, secure
table to trunnion. Please use (1) M8 flat washer
(2) M8 spring washer, and (3) M8x25 hex head
bolt to secure. (see Figure 4)
Eye Bolt
Figure 1
Handle Wheel
Figure 2
Figure 3
Figure 4
6
04/11/2019 Instructions Manual for BP-480 (W4344) 9