HADEF 53/22A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 11 / 19

5.52.187.00.01.10 11

Pull the free-wheeling wheel upwards in
direction ▲ .

The chain can be pulled through in both
directions.
A free-wheeling OFF
B free-wheeling switched ON
Illustration 12
Switching OFF the free-wheeling mechanism

Turn the free-wheeling wheel with one hand in
direction ◄ and pull the load chain at the same
time.

Free-wheeling wheel turns back to position
OFF.

Free-wheeling mechanism is switched OFF
C Switch OFF the free-wheeling.
D free-wheeling OFF
Illustration 13
7.3 Brake and pawl
The brake system needs a minimum load of 3% of the capacity.
Only this minimum load makes sure that the load-pressure-brake closes correctly. When the brake closes
correctly, the load is safely held.
DANGER!
Working situations with no guarantee that the minimum load is charged, are forbidden!
The brake remains closed (stuck) if:

The ratchet lever hoist is uncharged without lowering the load, i.e. in case of vertical lifting/lowering or in
case of horizontal pulling/tensioning.

The load hook is pulled against the housing and got stuck there.
The chain does not move, the load cannot be lowered.
Remedy:

Charge the ratchet lever hoist again

Release the brake by setting down the load.

OR: Turn the switching pin to position "Lowering" and release the hand lever with a strong jerk in direction
"▼".
8 Commissioning
8.1 General
The operator of the unit is responsible for the entire system.
According to the Ordinance on Industrial Safety and Health, a hazard analysis must be carried out by the
operator.
Observe the respective national standards, regulations and directives of the responsible bodies at the place
of operation.
NOTICE!
Hoists up to 1000 kg capacity and without motor-driven trolleys of hoisting unit must be tested by a
“qualified person” before putting into operation for the first time.
Hoists of 1000 kg capacity and up or with more than one motor-driven hoist movement; i.e. lifting and
trolley movement, must be tested by a “licensed qualified person” before putting in operation.
An exception is “hoists ready for operation” acc. validated national regulations with EU-declaration of
conformity.