Safety
6
5.52.187.00.01.02
2.3
Requirements for the operating personnel
The units may only be operated by qualified persons that are appropriately trained and that are familiar with
it. They must have their employer’s authorisation for operation of the units.
Before starting work, the operating personnel must have read the operating and installation instructions,
especially the chapter "Safety Instructions".
This is especially important for operating personnel that rarely uses the equipment, i.e. for installation or
maintenance work.
DANGER!
In order to avoid severe injury, please pay attention to the following when using the equipment:
Use protective clothes/equipment.
Do not wear long hair hanging down open.
Do not wear rings or other jewellery.
Do not wear cloths that are too big/wide.
Pos: 7.2.1.1 /2--SICHERHEIT/Ratschzug/*Bestimmungsgemäße Verwendung*/Alle @ 0\mod_1176281073785_52.doc @ 3604 @ @ 1
2.4 Appropriate
use
Appropriate use of the lever hoist is vertical lifting, lowering, pulling and tightening of loads.
Acc. to BGV D6 III§25(4) a ratchet lever hoist is a "unit ready for operation" and obtains the declaration of
conformity EU.
The permitted safe working load of the devices must not be exceeded!
It must be assured that the hoist can position itself in true alignment to the load.
The permitted environmental temperature during equipment operation is –20°C up to +40°C!
The units are not suitable for continuous operation!
Defective devices and load suspension devices must not be used until they have been repaired!
Only original HADEF spare parts must be used. Non-compliance will result in any warranty claims on
HADEF becoming void.
Liability and warranty will become void if unauthorized modifications of the units are made by the user!
Pos: 7.2.1.2 /---ALLGEMEIN/Hinweise/GEFAHR - Losreißen, Personentr., schweb.Lasten, ex verboten (H) @ 0\mod_1176815143933_52.doc @ 4805 @ @ 1
DANGER!
If the units are not used appropriately, it is not possible to ensure safe operation.
It is not allowed:
Pulling loose of stuck loads, dragging of loads and inclined pulling is not allowed.
The use in area at risk from explosion.
To transport people with the equipment.
Persons must not stand under a suspended load.
Motor drive of the equipment.
Blocking of the loose chain end.
Charging the loose chain end.
Dragging of loads with motor-driven hoists.
Pos: 7.2.2.1 /2--SICHERHEIT/Ratschzug/*Grundlegende Sicherheitshinweise*/Alle @ 0\mod_1176284043592_52.doc @ 3632 @ @ 1
2.5
Basic safety measures
NOTE!
When the hoists are used for lashing (i.e. to fasten loads on a lorry) we recommend to use hoists
with slipping clutch in order to avoid overloading.
Only use the hoists appropriately.
Never load the devices beyond their working load limit.
Pay attention to the accident prevention regulations (UVV).
Should the hoist be used outside of Germany, please pay attention to the national regulations that apply.
