5.52.262.00.01.08
19
1 Unscrew the screws of the cover and remove
the cover.
2 Loosen the central screw (1)
3 Set the switching point of every cam disc
(A,B…and possibly other) with set screw
(2A,2B…and possibly other).
4 Tighten the central screw (1) again.
5 Install the cover again and make sure the
rubber seal is placed correctly.
Illustration 17
Make sure that 2-3 rope layers remain on the
drum in the lowest load position.
Adjustment for "lifting" is done analogous.
Afterwards drive carefully to the end positions to
check correct adjustment.
Illustration 18
Pictures may differ from the actual design.
12.6
Pressure roller (as option)
Adjustment
Release the screw (1)
Turn the square (2) as far until the pressure
roller puts enough pressure on the wire rope.
Hold the square and tighten the screw (1)
again.
Illustration 19
12.7
Slack rope switch (as option)
12.7.1 Adjustment
Illustration - horizontally
Other versions are possible.
Insert the wire rope (1) under the guiding
pulley (4) and tighten it by the load.
Release the locking screw at the eccentric (6).
Turn the eccentric until it gets contact to the
tappet of the limit switch (3).
Secure the eccentric (6) with the locking screw.
Switch on the winch in direction "Lowering"
and relieve the wire rope (1).
Repeat this procedure if necessary until the
best switching point is found.
1
wire
rope
2 rope
drum
3 Spindle limit switch
4 Guiding
pulleys
5 roller
lever
6 eccentric
7 switching
shaft
Illustration 20
NOTICE!
Connection is, normally, effected in our factory, it is shown in the diagram.
