Installation
12
5.52.291.00.01.01
6 Installation
Pos: 10.2.1.1 /1_HADEF/6--MONTAGE/Winde + Seilzug/Allgemein/01.Allgemein - Alle @ 0\mod_1175003277025_52.docx @ 2819 @ @ 1
Please observe the following points in order to avoid any damage to equipment or injury of person:
Wear safety gloves.
Install the winch on a stable ground.
Make sure attachment surface is flat and that installation is made stress-free, - use shim parts if
necessary.
The winch must be set up and attached in such a way that it cannot change position neither by the load
nor by other influences.
Pos: 10.2.2.1 /1_HADEF/6--MONTAGE/Winde + Seilzug/Schrauben/42/87/02.Windenmontage 42/87 @ 1\mod_1245744000215_52.docx @ 10961 @ @ 1
6.1
Installation of winch
Type
Capacity
1st layer
kg
A B C
Ø D /
Anchoring
screws
Strength class
8.8
Number of
screws
1506
1515
1516
500 650
400
- 11/M10
4
2306
2309
2316
990 720
580
- 17/M16
4
2406
2409
2416
1000 720
580
- 17/M16
4
3405
3406
3416
2000 750
725
- 17/M16
4
4107
4108
3200 900
900
- 24/M22
4
5105
5106
5000 1000
1000
- 30/M27
4
6105 7500 1300
1300
100 26/M24
8
7104 10000 1410
1430
100 30/M27
8
Illustration 1
Pos: 10.2.3.1.1 /1_HADEF/6--MONTAGE/Winde + Seilzug/Drahtseil/*Allgmein*/03-1.Seilauswahl-Ü @ 2\mod_1283498256034_52.docx @ 15530 @ @ 1
6.2
Selection of wire ropes
Pos: 10.2.3.1.2 /1_HADEF/6--MONTAGE/Winde + Seilzug/Drahtseil/*Allgmein*/03-2.Seilauswahl-Alle-Seil nach EN @ 2\mod_1283498365267_52.docx @ 15534 @ @ 1
Wire ropes acc. to EN 12385-4 - Lifting ropes
Pos: 10.2.3.1.3 /1_HADEF/6--MONTAGE/Winde + Seilzug/Drahtseil/*Allgmein*/03-3.Seilauswahl-Alle @ 0\mod_1175004971345_52.docx @ 2858 @ @ 1
Stainless wire ropes and special wire ropes are available on request.
Diameter and nec. minimum breaking load must be acc. to the data mentioned in the table in chapter
"Technical Data" resp. acc. to the details mentioned on the type plate.
Recommendation of wire ropes
Steel-reinforced wire ropes
For larger pulling rope forces, fibre-core wire ropes can also be used.
For unguided loads, - non-twisting or at least twist-resistant wire ropes.
For several rope layers winded through the drum, - steel-reinforced wire ropes.
Pos: 10.2.3.1.4 /1_HADEF/---ALLGEMEIN/Hinweise/Seile/WARNUNG - Kunststoffseile verboten @ 0\mod_1177329455688_52.docx @ 5225 @ @ 1
WARNING!
It is not allowed to use plastic wire ropes or plastic-coated wire ropes.
Pos: 10.2.3.2.1 /1_HADEF/6--MONTAGE/Winde + Seilzug/Drahtseil/*Allgmein*/04.Seilbefestigung-allgmein P @ 2\mod_1279868443896_52.docx @ 15068 @ @ 1
6.3
Wire rope fastening
The winding direction of the wire rope is determined by the manufacturer.
The winding direction cannot be changed.
Before cutting the wire rope, wrap it firmly with a fine binding wire or strong adhesive tape.
Pos: 10.2.3.3.1.1 /1_HADEF/6--MONTAGE/Winde + Seilzug/Drahtseil/*05.Seilbefestigung*/42/87/1. 42/87 @ 1\mod_1245759228753_52.docx @ 10976 @ @ 1
