5.52.624.01.01.00
5
The permissible ambient temperature when operating the devices:
Type of drive
Device classification for
not explosive atmosphere
Explosive atmosphere
according to
ATEX
)* )**
Manually driven
-20°C/+50°C
-20°C/+40°C
Motor driven
-20°C/+40°C
-20°C/+40°C
) * At an atmospheric pressure range from 0.8bar to 1.1bar and an oxygen content of approx. 21%
) ** Devices of this category have been specially modified and labeled by the manufacturer
DANGER!
The ambient temperature range must not be exceeded!
DANGER!
It’s only allowed to use the unit in the EX-classification which is named on the type plate; or in lower
classes.
DANGER!
Not to be used with IIC gases and IIB gases hydrogen sulphide and ethylene oxide and light metal
and shock sensitive dusts!
It is not allowed to use the equipment in area at risk from explosion where gas AND dust does both
exist at the same time!
NOTICE!
If the units are not used as intended, safe operation is not guaranteed.
The operator alone is responsible for all personal injury and damage to property resulting from improper
use.
2.5
Basic safety measures
Observe installation-, operation- and maintenance instruction.
Pay attention to caution notes at units and in the manual.
Observe safety distances.
Take care for a free view on the load.
Only use this devices appropriately.
The equipment is to be used exclusively for movement of goods. It must not be used for transporting
people under any circumstances.
Never load the devices beyond their working load limit.
Observe the relevant national accident prevention regulations.
Building walls, ceilings, floors or constructions - on which the units are mounted or suspended - must be
checked by a structural engineer for sufficient stability.
After the unit has been standing for a longer period of time, visually inspect all components that are
important for its function and replace damaged components with new original spare parts.
Do not use a defective device.
Stop working immediately in case of disturbances and remedy failures.
Any damage and faults must be reported to a responsible supervisor immediately.
If the unit is put into operation, any persons in the immediate vicinity must be informed by calling to them!
Observe the provisions for load suspension equipment in accordance with the relevant national
regulations for the positive and non-positive slinging of loads.
The lifting tackle or the load must be securely attached to the device.
DANGER!
Special safety measures for use in areas prone to explosion.
