Hach QuikChem 8500 2 Series, Руководство по установке

Страница: 8 / 80

Attach the Z-drive to the sampler
Refer to the instructions that come with the sampler.
Attach the probe to the sampler
When the probe is installed, make sure that the probe is flush with the hole in the guide plate. Refer
to
Figure 2 .
Note: Always move the sliders with the wheel on the sampler to prevent damage to the tubing.
Figure 2 Probe installation
1 Probe guide plate (single probe
installation) 4 Probe slider 7 Slider knobs
2 Probe guide plate (dual probe
installation) 5 Probe
3 Slider wheel 6 Tie wrap
Install additional channels
If additional channels were ordered, attach the channels that are shipped separately. Use the
documentation that is shipped with the channels.
8 English