Hach QbD1200+, Руководство пользователя, Страница: 20 / 128

1. Push Maintenance > Replace Component .
2. Select an option.
Option Description
Replace Ozone
Filter Shows the hourly usage of the ozone filter. Shows how to replace the
ozone filter on the display.
Replace UV Lamp Shows the hourly usage of the UV lamp. Shows how to replace the UV
lamp on the display.
Replace Syringe Shows how to replace the syringe on the display. Push Start to replace
the syringe.
8.5 Install a firmware update
Locate the firmware update file on the product website. Save the file from the website to a USB flash
drive, then do the steps that follow to install the firmware upgrade.
1. Push Maintenance > Update Firmware .
2. Put the USB flash drive into a USB port. A list of files shows.
3. Select the setup.exe file for the firmware update.
4. Push Update .
5. Push Yes to confirm the update. The analyzer will reboot when the update is complete.
8.6 Prepare for shipment
N O T I C E
The instrument must be decontaminated before it is shipped. All fluids must be drained from the
instrument.
1. Push Maintenance > Prepare for Shipment .
2. Open the instrument door.
3. Remove the GLS water vessel. Refer to Product overview on page 3.
4. Discard the water into a drain.
5. Install the GLS water vessel back into the instrument.
6. Push Drain Analyzer to remove all liquid from the instrument.
7. When the instrument completes the draining procedure, the instrument is ready for shipment.
Section 9 Troubleshooting
Problem Possible cause Solution
The measurement does not
start. An error occurred during
measurement setup.
• Set the instrument power to
off, then to on.
• Contact technical support if
necessary.
The system test fails. An error occurred during the
system test.
• Make sure that the carrier
gas supply is correctly
connected.
• Contact technical support if
necessary.
A hardware component failure
occurred.
20 English