Hach K1100, Основное руководство пользователя

Страница: 10 / 542

If this female connector was supplied with a mains power plug already pre-attached (cable part
numbers 33031, 33032, 33033 and 33034) then the female connector can be plugged directly into
the instrument power connector. The two connectors are grooved to avoid an incorrect fitting. Tighten
the female connector to the instrument power connector finger-tight.
If no power cable was ordered with the equipment, a mains power plug must be connected to the
supplied female connector as described in the following procedure.
User-supplied power cable specifications:
• 3-wire (live, neutral and earth)
• cable Ø ≥ 7mm; ≤ 9.5mm
• wire selection ≥ 1mm
2
, AWG18; ≤ 2.5mm
2
, AWG14
Prepare the user-supplied power cable as follows:
1. Strip off 23 mm (0.9 ins.) of shielding from the power cable.
2. Cut back the live and neutral wires to 15 mm (0.6 ins.) in length but leave the earth wire as is.
3. Then strip off a small amount of external insulation from the three wires as required.
Wire the female connector as follows:
1. Take the narrow end of the connector ( 4 ) in one hand and the main body ( 2 ) in the other and
unscrew the two. Pull away the cable clamp ( 3 ) and unscrew the end plug ( 1 ) to reveal the four
parts that make up the connector.
2. Loosen the screws on the cable clamp ( 3 ) to allow enough room to pass the power cable through.
3. Pass the power cable through the end plug ( 1 ), the main body ( 2 ), and the cable clamp ( 3 ), and
then connect the three wires (live, neutral and earth) to the connector ( 4 ) as follows:
1. Live (brown)
2. Neutral (blue)
3. Not used
Earth - Earth (green and yellow)
Note: The numbers and earth symbol are stamped on the end of the connector. Ensure it is connected
correctly.
4. Slide the cable clamp ( 3 ) back onto the connector ( 4 ) and tighten the screws on the clamp to
secure the cable.
5. Screw the two parts ( 4 ) and ( 2 ) back together.
6. Secure the power cable by screwing the end plug ( 1 ) back in place.
7. The female connector can now be plugged directly into the instrument power connector. The two
connectors are grooved to avoid an incorrect fitting. Tighten the female connector to the
instrument power connector finger-tight.
4.7 Connections to electronic boards
N O T I C E
Potential Instrument Damage. Delicate internal electronic components can be damaged by static electricity,
resulting in degraded performance or eventual failure.
Note: Any loose connection wires should be bundled tightly together with the use of nylon cable ties.
Connectors P8 on the main board ( Figure 4 on page 11) and J7 on the measurement board
( Figure 6 on page 12) are made of two parts. Push down carefully the black levers on either side of
the connector and pull it out securely. Perform all connections with these connectors unplugged.
Once finished, attach the connectors to the boards by pushing them firmly in place (levers up).
10 English