Hach 900 MAX, Инструкция по эксплуатации инструмента

Страница: 75 / 160

Section 5
Page 73
8990options.fm
ORP Probe
The ORP probe consists of three wires; a pink, black, and red wire. There is
no temperature sensor on the ORP probe.
1. Attach the clear wire to either screw on the terminal strip labeled GLASS.
2. Attach the black wire to the REF screw on the other terminal strip.
3. Attach the red wire to the GND screw on the terminal strip.
5.3.2 ORP Probe Programming
1. From the Main Menu, select
OPTIONS>ADVANCED OPTIONS>DATALOG.
2. Highlight Select Inputs using the
UP
and
DOWN
keys and press
SELECT
.
3. Highlight ORP using the
UP
and
DOWN
keys, then press
SELECT
.
4. Press
CHANGE CHOICE
to cycle between Logged and Not Logged, then
press
ACCEPT
to continue.
5. Enter a logging interval, then press
ACCEPT
. Valid logging intervals are
shown on the status bar along the bottom edge of the display.
6. Select another channel to configure or press
RETURN
to back up one
step. Press
MAIN MENU
to return to the Main Menu.
5.3.3 ORP Probe Calibration
5.3.3.1 ORP Preamplifier/Junction Box Calibration
Calibration of the ORP input circuit requires a source of dc voltage between
500 and 2000 m V dc. The reference voltage must be applied to the ORP
input terminals on the preamplifier/junction box during calibration. A regulated
dc power supply or a standard “C” cell battery (1500 mV dc) make excellent
sources for reference voltage.
1. From the Main Menu, select
OPTIONS > ADVANCED OPTIONS >
CALIBRATION > ORP.
2. Install the ORP junction box on the sampler with the ORP probe removed.
3. Apply a positive reference voltage to the ORP probe terminals in the
junction box, using either a 1.5 V dc “C” cell battery or a regulated
power supply.
Table 9 ORP Connector Pin Assignments (J3)
Pin Signal Description Wire Color
A +5 V dc White
B ground Blue
C reference Yellow
D pH/ORP Black
E 5 V dc Red
F RTD Green