13
Using the chiller
1
．
Lift the lid and pour water into the tank up to the Maximum fill level. In the coming minutes water will
flow through the fast flow water filter into the water tank.
2
．
Keep adding water until all the tanks are full. Water flows through the filter at a set rate. It may take
some time to fill all the tanks on first use. During normal use top up the tanks regularly.
Note: After the unit has been drained, it is recommended to hold the dispensing lever open with
a glass while filling the tanks to stop air becoming trapped inside the unit. Once water flows
through the tap the dispensing lever can be released. If water fails to be dispensed when the
tanks are full. Please refer to " Troubleshooting " on page
15.
3
．
Close the lid.
4
．
Plug the unit into the mains and press the on/off switch on the panel. The blue indicator will illuminate
and the motor will begin to chill the water.
5
．
Dispense 2 liters of water from the unit to remove any unfiltered water and top up.
6
．
After up to 3 hours, the blue indicator on the panel will change to white indicating the water has chilled
to approximately 10
℃
. The motor will continue to chill the water down to approximately 5 degrees and
than stop. If the water temperature rises above 10 the motor will start to chill again.
7
．
Place a glass under the dispenser and push the lever back to dispense water. Top up the water tank as
necessary.
Note: it is possible to use the unit without power but the filtered water will not be chilled.
Using the filter status memo
Your Aqua optima double life water filter should be replaced regularly to enjoy the benefits of Strix Filtered
water. The filter status memo system automatically reminds you when your water filter needs to be
replaced.
When you have fitted and prepared your water filter, plug the main power and the status memo function
starts as shown below:
Every twelve days one ellipse will disappear to indicate the remaining filter life. After 60 days the filter icon
will start flashing as a signal that the filter must be replaced.
