Operating instructions 36007
Hot-pressing device
PQ-58
Page 7 of
20
Edition: 04/0312
Subject to alterations
4.
Hot-pressing of the belt/tape
Procedure:
For Hamid machine tapes
→
manual 32103 and individual product datasheets.
For spindle tape W-8, W-16
→
manuals 32110, 32111 and individual product datasheets.
Plug in electrical connecting cable and preheat hot-pressing device.
Preheating will take approx. 5 minutes. The light indicator (2) will change from a continuous light
during heating up to intermittent light as soon as the adjusted temperature is reached.
WARNING
Do not touch the hot-pressing zone (3).
Keep device away from water and meltable substances.
Open hot-pressing device by squeezing the handles (6) and place guide rail with inserted, prepared
belt/tape ends into the hot-pressing device, as described in the corresponding manual (also refer to
chapter 9).
Close hot-pressing device.
After the prescribed pressing time, remove guide rail and let it cool under pressure in a suitable device
→
chapter 9.
WARNING
After use, disconnect the hot-pressing device from the power supply and allow it to
cool completely before storing it.
