Operating instructions 36007
Hot-pressing device
PQ-58
Page 15 of
20
Edition: 04/0312
Subject to alterations
9. Required
accessories
9.1
Guide rails, clamps
These accessories are necessary for producing perfect fusion joints. The width and numbers of guide
rails to be used will depend on the width of the tape used and the requirements of the
machine/installation.
Once the tape ends have been inserted into the corresponding guide rail of fixed width
→
ill. (3), or
adjustable width
→
ill. (4) and fixed in place with the covering plate, the two clamps are applied at an
angle so as to prevent the tape from shifting during the hot-pressing process.
Place the guide rail in the precise center of the open hot-pressing device and close
→
ill. (5). This
assures uniform distribution of the heat to guide rail and joining area.
Illustration 3
Illustration 4
Illustration 5