Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-1056
Author: S.D.T.
/KM
REGULATIONS AND GENERAL WARNING NOTES
Edition: 02/2005
Page
A-10
Replaces: 01/2002
A.6
Safety warnings
When using industrial machines and systems, one should be aware that moving mechanical parts (linear
or rotary movement), high voltage electrical parts, and any parts at high temperature, etc, can cause
serious damage to persons and materials.
In designing and building the hot-pressing device, the Manufacturer focused special attention on safety in
order to supply a SAFE hot-pressing device and, therefore, the Manufacturer has provided protective and
safety devices considered necessary according to the Risk Analysis carried out by expert personnel.
People in charge of system safety must make sure that the following essential safety regulations are
observed:
Do not run the hot-pressing device with the fixed and mobile protective devices
dismantled or disabled.
Do not run the hot-pressing device with the fixed and mobile protective devices
dismantled or disabled.
It is forbidden to switch off safety devices installed on the hot-pressing device or
create by-pass systems to limit switches or micro-switches.
Operations with reduced safety devices must be carried out strictly observing the
instructions in the relevant descriptions, and must be performed by specialized
technicians aware of the risk, under the direct supervision of the company person
responsible for safety. Active protective devices must be restored as soon as
possible, limiting this high risk status to the minimum.
Cleaning and maintenance operations must be performed with the electrical and
pneumatic cut-out devices switched OFF. To this end, the hot-pressing device is
provided with emergency push-buttons which shut down the system. It is good
practice to use them as safety lock-outs to avoid accidental starting during
inspections or mechanical jobs.
Clean covers and control panel with soft, dry cloths lightly dampened in detergent;
do not use solvents as they could damage the surfaces.
Do not modify the hot-pressing device or its parts. Otherwise, the Manufacturer
shall not hold itself responsible for damage to persons and materials. Request
any modifications/customizing directly from the Manufacturer.
OFF
Hot-pressing device PM-1056
