Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-1056
Author:
S.D.T. / KM
INSTALLATION
Edition: 02/2005
Page
C-5
Replaces: 01/2002
C.3
Assembling and installation
Preliminary check
Carry out a visual check on the device’s appearance and on any accompanying equipment to see if there
are signs of damage or breakage that may have occurred in transit. If such damage and/or failures are
noted, contact HABASIT immediately. We advise you to also produce photographic evidence of the
damage.
C.3.1
Positioning
IMPORTANT
This operation requires the involvement of a QUALIFIED TECHNICIAN able to carry out and check
correct positioning in observance of current safety regulations:
Make sure there is sufficient operational space for working on the press.
Position the press so that it is stable.
Check visually to make sure that no rags, work tools, etc remain on the hot-pressing device.
C.3.2
Connection of air and water supplies
ATTENTION
The hot-pressing device can be used in Stationary operation mode (permanently connected to control
and regulation equipment) or in Mobile operation (when it is necessary to carry out work away from the
usual site).
Stationary operation
Ensure that the whole system is not supplied by electrical, air and water sources.
Ensure all the plant providing the equipment corresponds with its own specifications.
Use the pneumatic connection kit (code 008E1000), to connect the pressure cushions of the upper and
lower press parts.
The water and air power sources’ output is handled by the cooling unit
PMC-XX
. Referring to Section
B.4.4
ensure that the cooling unit suits to the press and regulating unit used.
Hot-pressing device PM-1056
