4
96-0012 rev G
June 2003
O
M
PERATOR’S
ANUAL
A u t o m a t i c
A u t o m a t i c
A u t o m a t i c
A u t o m a t i c
P a l l e t C h a n g e r
P a l l e t C h a n g e r
2.0 MAINTENANCE SCHEDULE
The following is a list of required regular maintenance for the HAAS Automatic Pallet Changer. These specifica-
tions,
especially the daily routine maintenance,
must be followed in order to keep your machine in good
working order and to protect your warranty.
P
ERIODIC
M
AINTENANCE
INTERVAL MAINTENANCE PERFORMED
IMPORTANT!!
Damage or misalignment may result from neglect of
daily maintenance.
DAILY
Clean chips, coolant, and other debris from the APC and receiver areas. Pay
special attention to the receiver clamping bars, and the pallet clamping rails
and wipers. Clean chips and coolant from receiver pallet clamped switch. Apply
a light coat of grease and work the grease into the plunger.
Do not over grease
.
WARNING
WARNING
WARNING
WARNING
WARNING:
Excessive chip buildup will require more frequent chip cleanup.
Clean the two locating pins in the receiver base and the corresponding bushings in
the pallets. Apply a very light coat of general purpose grease to the pins and
bushings, if needed.
Clean excessive chips and coolant from pallet drive chain.
WEEKLY
Remove the two 1/4" screws from the control panel and rotate to open position.
Clean chips and coolant from the drive sprocket and limit switch. Apply a light
coat of general purpose grease and work the grease into the switch plungers.
Check air gauge/regulator at the VMC lube/air panel for 85 psi.
Check condition of wipers. There are two wipers on each pallet.
INTERVAL
MAINTENANCE PERFORMED
MONTHLY
Check door for proper operation, both up and down. Clean and grease door side
guide rails as required.
MAINTENANCE
