HAAS + SOHN HSP 2.17, Инструкция по установке и эксплуатации

Страница: 13 / 31

13
8.1. Cleaning the surface
Dirt on the upper surface of the stove may be cleaned
off with a damp cloth or if necessary with mild soapy
water. You are advised against using corrosive cleaning
agents and solvents since these might damage the
surfaces.
8.2. Cleaning the glass panel
To clean the viewing panel, you must first open the
stove door. Dirt on the glass panel can be removed with
a glass cleaner or with a damp sponge on which you
have sprinkled some of the wood ash present.
(Environmentally friendly).
Cleaning the glass panel may only be done with a
cooled down stove in the OFF operating mode.
8.3.
Clean combustion chamber” function
instruction
Die The display on the operator console starts flashing.
(The backlighting switches on and off and the “Clean
combustion chamber” instruction appears).
The instruction to clean the combustion chamber refers
not just to the cleaning of the burner but also to the
cleaning of the entire combustion chamber with an ash
vacuum cleaner.
The process of the “Clean combustion chamber”
function looks like this:
The entire combustion chamber is to be cleaned with an
ash vacuum cleaner at intervals of no longer than 30
operating hours.
The process of
the “Clean combustion chamber”
function looks like this:
The entire combustion chamber is to be cleaned with an
ash vacuum cleaner at intervals of no longer than 30
operating hours.
However, this instruction to clean the combustion
chamber (display flashing) does not trigger an error
message during Heating mode. But after the display has
started flashing, if the stove switches
back to “Standby” mode, the stove can no longer be
automatically ignited before the combustion chamber
has been cleaned.
To clean the combustion chamber, the stove has to be
switched to “Off” operating status.
If the combustion chamber is now cleaned, then the
“Clean combustion chamber” error message will
thereafter be cleared automatically. A precondition for
the automatic clearance of this error message is that the
combustion chamber door is open for longer than 60
seconds in “Off” operating status. This time is required
for cleaning the combustion chamber including the
burner thoroughly with an ash vacuum cleaner.
If the door is open longer than 60 seconds
in “Off”
operating status , then the operating hours counter,
which is responsible for the “Clean combustion
chamber” instruction, is automatically reset to zero.
This reset of the operating hours counter occurs even if
the cleaning of the combustion chamber is performed
before the 30 operating hours have run provided that the
stove is in “Off” operating status and the door is open for
longer than 60 seconds during cleaning.
8.4. Cleaning the combustion pot -weekly
During operation, deposits may form in the combustion
pot. How quickly the combustion pot becomes dirty
depends solely on fuel quality. The deposits or
encrustations must be removed from time to time
.
Cleaning the combustion pot may only be done with a
cooled down stove in
“OFF” operating mode. Otherwise
there is a risk of burns!
To this end the combustion pot must be removed from
the stove. Once the combustion pot has been removed,
any residual ash that is in the stove underneath the
combustion pot must also be removed.
After cleaning, the combustion pot is to be put back into
the right position in the burner seat. Check the correct
seating of the combustion pot again so as to avoid poor
seals.
Figure 5: Burner dirty
Figure 6: Burner clean
The cleaning intervals for the combustion pot and the
glass panel depend directly on the quality of the wood
pellets (high ash content) and may vary between a few
hours of combustion and several days.