10
6.2.7 Fault screen
Quit
15:00 24.01.2004
Fault screen
Thermosensor flue gas
Interruption
Functions of the keys:
Left:
Key
inactive
Middle top:
Key inactive
Middle bottom: Display Info screen 1
Right:
Clear the fault on the display
6.3 Setting the language
With all devices, the language factory setting is set to
“German”.
If you would like to set another language, proceed as
follows:
In the main menu, place the cursor on “Language”.
Press the right “Select” key.
Select the desired language with the two middle keys.
Then press the right “Save” key.
If you would like to quit this screen without saving, press
the left “Back” key.
After saving, switch off the master switch and switch it
back on. It is only then that the texts will be displayed in
the language just selected.
6.4 Description – Heating profile
Setting range from 80 to 600
Factory setting: 80
The value to be set depends on the size of the room that
is to be heated.
Guideline values:
•
Room size 20m² - Value 80
•
Room 25m² - Value 200
•
Room 30m² - Value 400
•
Room bigger than 30m² - Value 600
With older stoves a higher value should be set (over
400) so as to avoid excess condensation in the fireplace.
The value of the heating profile is set as follows:
In the main menu, place the cursor on “Heating profile”
Press the right “Select” key.
Adjust the value with the two middle keys
Then press the right “Save” key.
If you would like to quit this menu screen without saving,
press the left “Back” key.
6.5 Description – Key lock (child-safe)
1
Menu
Room target/actual: 0/28°C
15:00 We,23.01.2004
Information
Operating mode: Auto
Operati ng status:S tandby
In Info screen 1 you can activate a key lock.
Activating the key lock:
•
Hold the Menu key down for about 10 seconds
until “Key lock activated” appears on the display.
Deactivating the key lock:
•
Hold the Menu key down for about 10 seconds
until “Key lock activated” is no longer shown on
the display.
6.6 Description – Display brightness - contrast
setting
Left key: Hold key down for about 10 seconds until
“Contrast mode” appears on the display.
Now release the left key and set the desired brightness
or contrast with the two middle keys.
7. Operating the pellet stove
The pellet stove may only be heated by adults. Make
sure that children are never left alone with the pellet
stove. (Do not leave the pellet stove unsupervised for a
long period). The pellet stove may only be used in
accordance with these operating instructions.
Please observe the safety instructions set out in Section
2.
7.1. Fuel
The pellet stove may only be operated with “pellet” fuel.
With this fuel you have chosen CO
2
-neutral heating for
your home.
Pellets are made from wood waste from sawmills and
planing works and from wood collected from forestry
businesses. These raw materials are therefore of 100%
natural origin and are ground, dried and pressed into
“pellet” fuel without the addition of binding agents.
This fuel is standardised (e.g. DIN 5173, Ö-Norm [Eco
standard] M 7135,
EN 14961-2
).
1
Back
Select
>Language German<
Main menu
Operating mode Auto
Date / Time
1
Back
Select
>Heating profile<
Main menu
Date / Time
Language German
