![background image](http://html.mh-extra.com/html/haaga/375/375_original-operating-instructions_575804027.webp)
haaga 375
haaga 477 / 497 Profi
27
EN
Troubleshooting
8. Troubleshooting
WARNING
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
•
Wear the prescribed personal protective
equipment!
CAUTION
Health impairments caused by dust
resulting from sweeping!
The inhalation of dusts can endanger the
health.
•
Wear the prescribed personal protective
equipment!
CAUTION
Risk of injury through tipping over of the
sliding bracket!
Tipping over of the sliding bracket may lead to
slight injuries, such as jamming of the fi nger or
haematomas in users or other persons.
•
When carrying the device, hold it so that the
sliding bracket cannot tip over.
Faults may occur even if the prescribed
maintenance work and checks of the device
before use are complied with. Possible faults are
listed in the table below, with specifi cation of the
cause and remedy.
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
•
Wear the prescribed personal protective
equipment!
Health impairments caused by dust
resulting from sweeping!
The inhalation of dusts can endanger the
health.
•
Wear the prescribed personal protective
equipment!
Risk of injury through tipping over of the
sliding bracket!
Tipping over of the sliding bracket may lead to
slight injuries, such as jamming of the fi nger or
haematomas in users or other persons.
•
When carrying the device, hold it so that the
sliding bracket cannot tip over.
8.1 Fault table
Fault
Cause
Remedy
Device is
running with
diffi culty or
roughly
Device is
contaminated
Clean device, see
Section 9.5
Broom blocked
Remove blockage see
Section 9.3 “Remove
blockage”
Contaminated
broom drives
Clean broom drives,
see Section 9.5 “Clean
device”
Height
adjustment
is set too
low, contact
pressure of the
plate brooms
too high
Set height adjustment,
see Section 7.2 in the
section “Adjust height of
plate brooms”
Plate brooms do
not rotate
Contact Service
Bristles are
bent
Improper
storage
Align the bristles, see
Chapter 9.4 in the
section “Align bristles”
Sweeping
result is
insuffi cient
Sweeping lip is
missing, loose
or worn
Replace sweeping lip