2-8
Installing the device by using front mounting brackets and
slide rails
The slide rails are optional components that need to be separately ordered if needed. The slide rails
in this example are for illustration only.
To install the device by using front mounting brackets and slide rails:
1.
Wear the ESD wrist strap and verify that the rack is sturdy and is reliably grounded.
2.
Use the screws supplied with the front mounting brackets to attach the front mounting brackets
to the device, as shown in
3.
Attach the slide rails to the rack. See
Figure2-11 Installing slide rails
4.
Holding both sides of the device, push the device in the rack along the slide rails, as shown in
. Make sure the chassis bottom makes close contact with the bottom flanges of the
slide rails.
