12
Use
undo irf member stack enable
to disable multimember stacking capability for an IRF member
device.
Syntax
irf member member-id
stack
enable
undo irf member member-id
stack
enable
Default
Multimember stacking capability is enabled for an IRF member device.
Views
System view
Predefined user roles
network-admin
Parameters
member-id
: Specifies an IRF member device by its member ID.
Usage guidelines
If multimember stacking capability is disabled for a device, the device cannot join an IRF fabric that
contains other devices.
You can use the
undo
form of this command to remove a member device from an IRF fabric for
troubleshooting or maintenance purposes. The removed member device still runs the original IRF
settings. However, it does not send or receive IRF control packets.
After you finish the troubleshooting or maintenance tasks, you can log in to the removed device and
execute this command to add the device back to the IRF fabric. For this command to take effect, you
must save the command setting and reboot the device.
Examples
# Remove member device 2 from the IRF fabric.
<Sysname> system-view
[Sysname] undo irf member 2 stack enable
Member 2 will leave from the IRF and cannot form an IRF with any other devices. Continue?
[Y/N]: y
Operation succeeded. Please check the configuration on member 2 with the IRF for
configuration collisions.
# Add the removed device back to the IRF fabric.
<Sysname> system-view
[Sysname] irf member 2 stack enable
Please save the configuration, and then reboot the device for the configuration to take
effect.
irf topo-domain
Use
irf topo-domain
to specify an IRF topo-domain ID.
Use
undo irf topo-domain
to restore the default.
Syntax
irf topo-domain topo-domain-id
undo irf topo-domain
