2-13
2.
Attach the split sealing washer to the cable, connect the Ethernet cable to the target port on
the AP, and insert the sealing washer into the weatherproof connector.
Figure2-20 Connecting an Ethernet cable
3.
Use a wrench or wear nonslip gloves to fasten the sealing nut and the weatherproof connector.
Figure2-21 Fastening the sealing nut and weatherproof connector
4.
Start wrapping at the top of the connector. Smooth the tape edges to ensure full adhesion.
Figure2-22 Wrapping the connector
Connecting a fiber cable
WARNING!
•
To avoid cable damage, do not pull the fiber cable with excessive force.
•
To avoid affecting fiber performance, make sure the fiber cable is not bended or folded when
fastening the sealing nut.
IMPORTANT:
•
Before connecting a fiber cable, remove the dust caps from the fiber connectors.
•
To use a fiber pigtail that does not have any protective sleeve, first use weatherproof tape to
wrap the fiber pigtail before you connect the fiber pigtail.
To connect a fiber cable:
1.
Use weatherproof tape to start wrapping below the fiber connector, build up the fiber cable
diameter near the opening in the split sealing washer. Smooth the tape edges to ensure full
adhesion.
