10
Mounting the AP on a wall
No expansion screws are provided with the AP. Prepare four sets of 6 × 60 or 6 × 80 expansion
screws, flat washer, spring washer, and nut yourself.
To install the AP on a wall:
1.
Mark the installation holes on the wall by using the mounting bracket, as shown in
.
Figure 9 Marking the installation holes on the wall
2.
Drill holes with a diameter of 8 mm (0.31 in) and a minimum depth of 60 mm (2.36 in) in the
marked positions. Insert an expansion screw into each hole, and tap the expansion screw with
a rubber hammer until it is all flush with the wall surface, as shown in
.
When you drill holes, follow these restrictions and guidelines:
{
Hold the drill handle with both hands, with the bit vertical to the wall surface, and prevent
wall damage or tilted holes.
{
If the wall surface is too solid and slippery to locate the bit, punch a notch first.
{
Each hole must have the same depth.
150 mm
(5.91 in)
48 mm
(1.89 in)
