User Manual
H3C VG 10-10/10-11 Voice Gateway
Chapter 3 Web Configuration Guide
3-3
The default factory setting user information of VG 10-10/10-11 is listed in Table 3-2. It is
recommended that you change the password for the first login, refer to 4.2.3 Modifying
User Password for related details.
The Web page will time out if no operation is performed within five minutes after you log
in. For security, the system will then return to the login page and require you to enter the
password again. The Web page language remains the previous one set before timeout.
If you close the Web page, the language defaults to English when you login next time.
Caution:
z
Before login, make sure that the IP addresses of the PC and the voice gateway are
configured in the same network segment or the route between the two addresses is
reachable.
z
If you use the management IP address to log into the voice gateway, make sure that
the PC is connected to the LAN port of the voice gateway.
z
There can be another device that has the same management IP address with the
VG 10-10/10-11; however, there cannot be any device having an interface IP
address conflicting with that of the voice gateway, which may affect the normal
operation of the voice gateway.
3.3 Overview on Configuration Web Page
The following is the Web page of VG 10-10/10-11. By clicking any item in the navigation
bar (on the left side of the page), you can view the corresponding configuration
information on the right side of the page, where you can view or modify the
configuration information of the voice
