H3C UniServer R2700 G3, Руководство пользователя

Страница: 67 / 226

6-31
11.
Connect the front I/O component cable assembly. For more information, see " Connecting the
front I/O component cable assembly ."
12.
Install the access panel. For more information, see " Installing the access panel ."
13.
Rack-mount the server. For more information, see " Rack-mounting the server ."
14.
Connect the power cord. For more information, see " Connecting the power cord ."
15.
Power on the server. For more information, see " Powering on the server ."
Installing an optical drive
Preparing for the installation
Use Table 6-2 to determine the location of the optical drive you are installing depending on the type
of the optical drive.
Table 6-2 Optical drive installation locations
Optical drive Installation location
USB 2.0 optical drive Connect the optical drive to a USB 2.0 or USB 3.0 connector on the server.
SATA optical drive
•
4LFF server: Optical drive slot.
•
8SFF server: Optical drive slot.
•
10SFF server: Not supported.
For the location of the optical drive slot, see "Front panel view."
Installing a SATA optical drive on the 4LFF server
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
5.
Press the clip on the right side of the blank in the optical drive slot until the blank pops out
partially, and pull the blank out of the slot, as shown in
Figure 6-45 .
Figure 6-45 Removing the blank from the optical drive slot