H3C UIS-Cell 3000 G3, Руководство пользователя

Страница: 58 / 171

51
6.
Insert the riser card in the PCIe riser connector, as shown in Figure 66 .
Figure 66 Installing the riser card
7.
Connect PCIe module cables, if any.
8.
Install the access panel. For more information, see " Installing the access panel ."
9.
Rack-mount the server. For more information, see " Rack-mounting the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."
Installing a UIS-RC-GPU/FHHL-2U-G3-F1 riser card and a
PCIe module
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the screws from the riser card blank in PCIe riser connector 1 or 2, and then lift the
blank until it is unseated from the connector, as shown in
Figure 67 . This example uses PCIe
riser connector 2 to show the installation procedure.