H3C Super Controller, Руководство по установке

Страница: 11 / 24

7
Installing Unified Platform
Supper Controller runs on Unified Platform as a component. Before deploying Supper Controller, first
install Unified Platform. For more information, see
H3C Unified Platform Deployment Guide .
Partitioning drives
Configure drives as described in " Hardware requirements ." Partition the drives as described in Table
12 or Table 13 .
Table 12 Drive partition settings (2400 GB system drive)
RAID
configuration Partition
name Mounting
point Minimum
size
Remarks
RAID 10, with a
total drive size
≥
2400 GB
/dev/sda1 /boot/efi 200 MiB
EFI system partition, required
only in UEFI mode
/dev/sda2 /boot 1024 MiB N/A
/dev/sda3 / 1000 GiB
Supports capacity expansion
when the drive size is sufficient
/dev/sda4 /var/lib/docker 500 GiB
Supports capacity expansion
when the drive size is sufficient
/dev/sda6 swap 1024 MiB Swap partition
/dev/sda7 /var/lib/ssdata 550 GiB
Supports capacity expansion
when the drive size is sufficient
/dev/sda8 N/A 300 GiB
Reserved for GlusterFS.
Configuration for this partition is
not required during operating
system installation.
RAID 1, with a total
drive size
≥ 50 GB
/dev/sdb /var/lib/etcd 50 GiB
•
Deploy Supper Controller in
a version earlier than E3105
on Unified Platform in a
version earlier than E0706
(including E06xx). Make
sure etcd has an exclusive
use of a physical disk.
•
Deploy Supper Controller in
E3105 or a later version on
Unified Platform in E0706 or
a later version. etcd can
share a physical disk with
other partitions. As a best
practice, use a physical disk
exclusively for etcd.
Table 13 Drive partition settings (1920 GB system drive)
RAID
configuration Partition
name Mounting
point Minimum
capacity
Remarks
RAID 10, with a
total drive size
≥
1920 GB
/dev/sda1 /boot/efi 200 MiB
EFI system partition
This partition is required only in
UEFI mode.