79
Step
Command
Remarks
7.
Assign the port an
aggregation priority.
link-aggregation
port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of ports in the
dynamic aggregation group.
8.
Set the LACP timeout interval
on the port to the short timeout
interval (1 second).
lacp period short
Optional.
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Configuring an aggregate interface
You can perform the following configurations on an aggregate interface:
•
Configuring the description of an aggregate interface or subinterface
•
Configuring the MTU of a Layer 3 aggregate interface or subinterface
•
Enabling link state traps for an aggregate interface
•
Setting the minimum number of Selected ports for an aggregation group
•
Shutting down an aggregate interface
•
Restoring the default settings for an aggregate interface
Configuring the description of an aggregate interface or
subinterface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface or subinterface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter aggregate interface
view.
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface or subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Use either command.
