80
Step
Command
Remarks
3.
Configure the description
of the aggregate interface
or subinterface.
description
text
Optional.
By default, the description of an
interface is in the format of
interface-name
Interface
, such as
Bridge-Aggregation1 Interface
.
Configuring the MTU of a Layer 3 aggregate interface or
subinterface
The maximum transmission unit (MTU) of an interface affects IP packets fragmentation and reassembly on
the interface.
To change the MTU of a Layer 3 aggregate interface or subinterface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 3 aggregate
interface or subinterface view.
interface route-aggregation
{
interface-number
|
interface-number.subnumber
}
N/A
3.
Configure the MTU of the
Layer 3 aggregate interface
or subinterface.
mtu
size
Optional.
The default setting is 1500 bytes.
Enabling link state traps for an aggregate interface
You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see
Network Management and
Monitoring Configuration Guide
.
To enable link state traps on an aggregate interface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the trap function
globally.
snmp-agent trap enable
[
standard
[
linkdown
|
linkup
] * ]
Optional.
By default, link state trapping is
enabled globally and on all
interfaces.
3.
Enter aggregate interface
view.
•
Enter Layer 2 aggregate interface
view
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface or
subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Use either command.
