2-11
Figure2-9 Attaching the front mounting brackets (port side mounting position) and shoulder
screws to the chassis
Figure2-10 Attaching the front mounting brackets (power supply side mounting position)
and shoulder screws to the chassis
Attaching the rear mounting brackets to the rack
1.
Determine the switch installation position in the rack.
2.
Orient the rear mounting brackets with the wide flange inside or outside the rack as required, as
shown in
3.
Use M6 screws and cage nuts to attach the rear mounting brackets to the rear rack posts. As a
best practice, use a torque of 30 kgf-cm (2.94 Nm) to fasten the M6 screws.
Make sure the corresponding cage nuts on the left and right rear rack posts are at the same
height.
Do not fully tighten the M6 screws before mounting the switch in the rack.