H3C S5560-HI Series, Руководство по установке, Страница: 67 / 85

59
NOTE:
USB devices from different vendors vary in compatibilities and drivers. H3C does not guarantee the correct
operation of USB devices from all vendors on the switch. If a USB device fails to operate on the switch,
replace it with one from another vendor.
10/100/1000BASE-T autosensing Ethernet port
Table 17 10/100/1000BASE-T autosensing Ethernet port specifications
Item Specification
Connector type RJ-45
Interface attributes 10/100/1000 Mbps, full duplex, MDI/MDI-X auto-sensing
Max transmission
distance
100 m (328.08 ft)
Transmission medium Category-5 (or above) twisted pair cable
Standards IEEE 802.3i, 802.3u, 802.3ab
1/10GBASE-T autosensing Ethernet port
The LSWM2XGT2PM and LSWM2XGT8PM interface cards provide 1/10GBASE-T autosensing Ethernet
ports.
Table 18 1/10GBASE-T autosensing Ethernet port specifications
Item Specification
Connector type RJ-45
Interface attributes 1/10 Gbps, full duplex, MDI/MDI-X auto-sensing
Transmission medium
and max transmission
distance
•
Category-6 UTP —55 m (180.45 ft)
•
Category-6 STP —100 m (328.09 ft)
•
Category-6 SFTP —100 m (328.09 ft)
•
Category-6 and above twisted pair —100 m (328.09 ft)
Standards IEEE 802.3ab and 802.3an
SFP+ port
The switch provides fixed SFP+ ports. To connect the peer SFP+ ports over a long distance, use SFP/SFP+
transceiver modules and fibers. To connect the peer SFP+ ports over a short distance, use SFP+ cables.
You can install the 1000 Mbps SFP transceiver module in Table 19 and 10 Gbps SFP+ transceiver
modules in Table 20 in the SFP+ ports.