H3C S3610-28F, Руководство по эксплуатации

Страница: 29 / 1547

Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 Logging in Through the Console Port
2-1
Chapter 2 Logging in Through the Console Port
Note:
The default system name of S3610&S5510 series Ethernet switches is H3C, that is, the
command line prompt is H3C. All the following examples take H3C as the command
line prompt.
2.1 Introduction
To log in through the Console port is the most common way to log into a switch. It is also
the prerequisite to configure other login methods. By default, you can log into an
S3610&S5510 series Ethernet switch through its Console port only.
To log into an Ethernet switch through its Console port, the related configuration of the
user terminal must be in accordance with that of the Console port.
Table 2-1 lists the default settings of a Console port.
Table 2-1 The default settings of a Console port
Setting Default
Baud rate 9,600 bps
Flow control Off
Check mode No check bit
Stop bits 1
Data bits 8
After logging into a switch, you can perform configuration for AUX users. Refer to
section 2.3 “ Console Port Login Configuration ” for more.
2.2 Setting Up the Connection to the Console Port
z
Connect the serial port of your PC/terminal to the Console port of the switch, as
shown in Figure 2-1 .