H3C S12502X-AF, Быстрый старт

Страница: 15 / 29

12
Installing the filler panel
1. As shown by callout 1 in Figure 11 , align the two captive screws on the filler panel with the
installation holes on the slot.
2. As shown by callout 2 in Figure 11 , fasten the captive screws on the filler panel.
Figure 11 Installing the filler panel
Installing cable management brackets
CAUTION:
To avoid device damage, press the spring tab when you remove a cable management bracket.
The cable management brackets are installed on the two sides of the LPU slots. As a best practice,
install cable management brackets after you have installed LPUs.
As shown in Figure 12 , insert the cable management bracket end that has a spring tab into the
cable management bracket hole until the bracket has close contact with the hole.
Figure 12 Installing a cable management bracket
(1) Spring tab on the cable management bracket
(2) Align the cable management bracket with the bracket hole
2
2
1