8
To remove the power module:
1.
Turn off the circuit breaker at the power input end.
2.
Wear an ESD wrist strap and make sure the strap makes good
skin contact and is reliably grounded.
3.
Remove the power cord.
4.
As shown in
, press the latch towards the handle, and
pull the power module part way out of the slot along the guide
rails.
5.
Holding the power module handle with one hand and supporting
the power module bottom with the other, pull the power module
slowly out of the slot along the guide rails.
6.
Put the removed power module on an antistatic mat or into its
package.
7.
If you are not to insert a power module into the empty slot, insert
the filler panel into the slot to prevent dust from entering the
chassis.
Figure 7 Removing the power module
Copyright © 2016-2017 New H3C Technologies Co., Ltd.
