H3C PSR560-56D, Руководство пользователя

Страница: 5 / 8

5
2. Unpack the power module and verify that the power module
model is as required.
3. Remove the filler panel as shown in Figure 3 , if any, from the
target power module slot.
{
Put your finger into the hole in the filler panel and pull the
filler panel out along the guide rails.
{
Insert a flat-blade screwdriver through the handle on the filler
panel and pull the filler panel out along the guide rails.
Figure 3 Removing a filler panel
4. Insert the power module into the slot, as shown in Figure 4 :
a. Correctly orient the power module with the characters
upward.
b. Holding the power module handle with one hand and
supporting the power module bottom with the other, slide the
power module along the guide rails into the slot. When the
power module is completely inserted into the slot, you can
hear that the latch of the power module clicks into the slot.
If the power module is not aligned with the slot, pull out the
power module, adjust its direction, and insert it again.