H3C NSQ1GT48EA0, Руководство пользователя

Страница: 2 / 3

Manual Version: 6PW104-20170414 BOM: 3123A0R7
ii
Item Specification
Ambient humidity
•
Operating: 10%RH to 95%RH, noncondensing
•
Storage: 5%RH to 95%RH, noncondensing
Compatible device model and slot
•
M9006 gateway (slot 2 to slot 5)
•
M9010 gateway (slot 0 to slot 3 and slot 6 to slot 9)
•
M9014 gateway (slot 0 to slot 5 and slot 8 to slot 13)
•
T9006 IPS (slot 2 to slot 5)
•
T9010 IPS (slot 0 to slot 3 and slot 6 to slot 9)
•
T9014 IPS (slot 0 to slot 5 and slot 8 to slot 13)
3 LEDs
The NSQ1GT48EA0 provides LEDs to show the operating status of the LPU.
Table 2 LED description
Status Description
Flashing The port is sending or receiving data.
On A link is present.
Off No link is present.
4 Installing and removing the NSQ1GT48EA0
CAUTION:
•
Wear a well-grounded ESD-preventive wrist before you install or remove the LPU.
•
Do not touch the surface-mounted components directly with your hands when you install or remove
the LPU.
4.1 Installing the NSQ1GT48EA0
1.
Face the front panel of the device.
2.
Identify the slot to install the LPU, and remove the filler panel from the slot.
This manual uses slot 3 as an example.
3.
Place the LPU horizontally with the surface-mounted components facing upward. Pull outward the
ejector levers and gently push the LPU in along the slot guide rails until the LPU is in close contact
with the backplane. (See callout 1 in Figure 3 .)
4.
Push the ejector levers inward. (See callout 2 in Figure 3 .)
5.
Tighten the captive screws with a Phillips screwdriver to secure the LPU in the slot. (See callout 3
in
Figure 3 .)