i.
P2 Mode(Master): The same mode as “P2” mode with the mode selection
switch
1.
Go to configuration mode. Please see the section “2. Gateway
configuration” with “setting” checked.
2.
Click “Start” for searching devices. As the result, a list of Bluetooth
devices available is shown in “Device List.”
3.
Select one device and click “Pairing.”
4.
Information about the process will be shown in “Bluetooth Log.”
ii.
P1 Mode(Slave): The same mode as “P1” mode with the mode selection switch
1.
Go to configuration mode. Please see the section “2. Gateway
configuration” with “setting” checked.
2.
Click “Start” to make gateway be pairing standby mode.
3.
Information about the process will be shown in “Bluetooth Log.”
4.
Measurement and data transmission
1)
How to use
A.
Take a reading, and then the reading is transmitted to the gateway by Bluetooth.
B.
And the reading is automatically transmitted to the server via mobile networks.
C.
At server access failure, it tries 9 more times, in total 10 times at most with 1 hour
period until success.
2)
Clock setup
A.
Clock of the gateway is automatically set with CDMA connection.
B.
Clocks of measuring devices can be set during communication with the gateway.
C.
But, regarding the IEM’s blood pressure monitor, clock must be set manually.
3)
LED indications
A.
During Bluetooth communication, the “Readings” LED turns GREEN.
B.
At success, the “Readings” LED blinks GREEN 5 times.
C.
At failure, the “Readings” LED blinks RED 5 times.
D.
During server connections, the “Sending” LED turns GREEN.
E.
At success, the “Sending” LED blinks GREEN 5 times.
F.
At failure, the “Sending” LED blinks RED 5 times.
4)
Notification for power failure
A.
The gateway is supposed to connect to a server when an AC adapter is connected
and disconnected.
B.
It sends “Power up” and “Power down” signals, respectively.
C.
Backup batteries are required.
5)
Heart beat
A.
Server access is taken every six hours for indication “I’m alive.”
B.
If there is any reading unsent, the reading is sent to a server together.
5.
Data collection software
1)
Setup
A.
Default path :
C:\Program Files\H3SYSTEM\DataCollection_GPRS\DataCollection_GPRS.exe
B.
Configuration file name: gprs_config.ini
C.
Contents of configuration file (gprs_config.ini)
