H2X THERAPOOL D, Руководство пользователя, Страница: 28 / 108

26 DO NOT DIVE. 100 DO NOT DIVE.
Regular Maintenance Procedures
NOTE: These maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
CLEANING JETS
The majority of jets in your swim spa can individually be turned on/off. If any of these jets become
hard to turn, it will be necessary to remove the jet to clean it as grit/sand and mineral deposit may
be present.
The jets in your swim spa can be removed for cleaning by unscrewing them (counter clockwise)
and then pulling out the jet.
To Clean Jets
Place the jet(s) in a container, fully immerse in white vinegar. Let the jet(s) soak overnight and then
rinse with water. It may be necessary to clean grit and deposits from the white jet body (mounted
in the swim spa shell) by using a small bristled brush.
CLEANING DIVERTER VALVES
Mineral deposits, grit and sand may get into the internal parts of the diverter valves over time. The
diverter valves may become difficult to turn or not turn at all.
Remove the handle from the top of diverter valve by gently prying up on both sides of the handle
assembly at the same time.
Turn the cap piece counter clockwise. It may be necessary to put a clean towel over the cap and
turn it with a wrench.
Once loose, the cap, internal rotor assembly and handle can be pulled up out of the white plumb-
ing fitting.
Wipe down the internal rotor assembly that attaches to the cap and handle.
Soak the internal rotor assembly in white vinegar.
The inner wall of the white plumbing fitting should also be wiped down. If the surface of the
white plumbing has become too abrasive, you can take wet, fine sandpaper and smooth it out.
Rinse the diverter internals and reassemble.
In the future, it is helpful to turn the diverter valve only when the pump is not on. Cleaning your
diverter valve should occur every time you drain your swim spa. Refer to Draining Your Swim Spa
in the Regular Maintenance Procedures section.