ELECTRONIC CONTROL PANEL
Page 8
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS
Before entering the programming mode, make sure that
the appliance is in service mode.
In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll
button and hold it for 2 sec until the
display shows:
Press the up
or down
button to set the
language.
2.
Press the scroll button again; the display will show:
Press the up
or down
button to set the time of
day.
3.
Press the scroll button again; the display will show:
Press the up
or down
button to set the unit of
measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4.
Press the scroll button again; the display will show:
Press the up or down button to set the hardness
of the incoming untreated water.
5.
Press the scroll button again; the display will show:
Press the up or down button to save the settings
into the NOVRAM® and exit the programming mode.
PROGRAMMING INSTRUCTIONS -
CONFIGURATION PARAMETERS
All configuration parameters on this appliance have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
See table at the end of this manual for default configuration
parameter settings.
Before entering the programming mode, make sure that
the appliance is in service mode.
In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll
button and hold it for 6 sec until the
display shows:
2.
Within 10 sec, press the up
button; the display will
show:
Press the up
or down button to set the units of
measure (Metric or US).
3.
Press the scroll button again; the display will show:
Press the up
or down
button to activate the
maintenance reminder function by setting the
maintenance interval, or deactivate the maintenance
reminder function.
4.
Press the scroll button again; the display will show:
Press the up
or down
button to set the
exchange capacity per litre of resin.
5.
Press the scroll button again; the display will show:
Press the up
or down
button to set the volume
of resin.
6.
Press the scroll button again; the display will show:
Press the up or down button to set the number
of days between regenerations.
7.
Press the scroll button again; the display will show:
Press the up
or down
button to set the length
of the regeneration cycle.
Cycle 1: XXX sec
System Check
Resin:XXX liters
ExCap:5.1°f M3/L
Override: 7 days
Language:English
Set time: 8:01
Set Hardn: XX °f
HardUnit: °f
Exit
Units:Metric
MaintInt: OFF
