SYSTEM AND FAUCET DIAGRAM
Insert tube
1
Push up to tube stop
2
Pull to check secure
3
Disconnecting
4
1.
Fitting grips before it seals. Ensure tube is pushed into the tube stop.
2.
Push the tube into the fitting, to the tube stop. The collet (gripper) has
stainless steel teeth which hold the tube firmly in position while the O-ring
provides a permanent leak-proof seal.
3.
Pull on the tube to check that it is secure. It is a good practice to test
the system prior to leaving site and/or before use.
4.
To disconnect, ensure the system is depressurized before removing the
tube. Push in collet squarely against face of fitting. With the collet held in
this position, the tube can be removed.
The fitting can then be re-used.
Note: See exploded diagram (on last page of this
manual) regarding locking clips and plugs.
How to make a Quick-Connect Connection
Содержание USRO4-50-JG
Страница 8: ......
