2
Checklist content
•
Control Unit
•
2 Transducers, incl. 10 meter cable
•
Loctite 3090 Glue
Note if the box shows any damages, claim with freight carrier within 24 hours of delivery, keep the damaged shipping box until
the carrier’s representative has inspected it.
If necessary, contact H2O Marine for further assistance.
Installation of the control unit
Position the control unit such that you have access to a 12 Volt DC power source and can route the transducer cables.
Identify a suitable location for the control-unit:
•
Clean and dry
•
Well ventilated
•
Ambient temperature of -10° C (14° F) and 50° C (122° F)
•
Protected from airborne particulate, moisture and dirt.
Mount the control-unit using the 4 holes underneath the holes for the screws of the lid. Connect the control box to a 12 Volt
DC power outlet. Watch polarity! On the big Techno connector the terminal number 1 is positive and the terminal number 3 is
negative.
The electronics are designed for a maximum of 14,5 Volts, which occurs when the alternator or the shore power battery
charger kicks in. Native operating power for the unit is 12 Volt DC.
H2O Marine B.V.
Burg. Loeffplein 70E, Office 32, 5211 RX, ’s-Hertogenbosch - The Netherlands - +31 (0)85 060 2837 - www.h2o-marine.com - [email protected]
