User’s Manual & Warranty
H2O-GSB3C | H2O-GS/FB/3C
USING THE H2O-GS/FB/3C TO FILTER WATER
WARNING:
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Step 1:
Before plugging unit in, thoroughly wash all removable parts (except
fi
lter cartridge) with warm
water and detergent before use. Rinse thoroughly.
Step 2:
Wash out the water cooler by
fi
lling the tank with water and
fl
ushing the water through the taps.
Repeat this process if necessary.
Step 3:
Put
fi
lter bottle together as shown on page (5). Make sure Filter bottle ring is placed on the unit,
and sit the
fi
lter bottle on top.
Step 4:
Prepare the
fi
lter cartridge as per Filter Replacement instructions on page (8).
Push
fi
lter cartridge
fi
rmly in place.
Step 5:
Pour 1-1.5L/ 34-52oz of water into unpuri
fi
ed water tank. Allow water to
fi
lter through to the
puri
fi
ed water tank and to chill reservoir tank within unit.
Note:
First
fi
ltration will take longer than subsequent.
Step 6:
Add a further 1-1.5L/ 34- 52oz of water to completely
fi
ll the
fi
lter bottle. Do not exceed the
indicator
fi
ll lines.
Step 7:
Discard water from
fi
rst
fi
ll through taps.
Step 8:
Repeat steps 5 & 6.
Step 9:
Place lid on top and set
fi
lter change dial to indicate the month of your installation. This device
will then indicate at ‘Replace’ mark the recommended month in which you should replace
the
fi
lter cartridge. We recommend changing the
fi
lter approximately every 2 months or after
dispensing 150L / 40 gallons of water.
Step 10:
Plug in unit, turn on rear power switch. Allow unit to cool water then use.
Note:
Once water has been chilled unit will go into a low power mode and chilled light will dim.
Содержание H2O-3C
Страница 1: ......