H-KING Savage Bobber 1000 mm 5ch ARF Version, Инструкция по эксплуатации

Страница: 8 / 19

AILERON SERVO & FLAP INSTALLATION:
First, make a cut in the covering at the servo horn opening and trim the area neatly on the servo mounting
plate with a hobby knife as shown. Secondly, position the servo in the center on the servo mounting plate,
and glue the supplied wooden mounting blocks onto the mounting plate as shown. Ensure the servo horn
sits right in the middle of the opening without any interference of the servo arms movement whilst the glue
dries. After that, install the aileron servo by using the self-tapping screws which come with your servo.
Finally, get a piece of masking tape to hold both the servo lead and the piece of thread which is buried
inside the wing together. This will then allow you to slowly pull the servo lead through the wing and out of
the wing root fairly easily.
Note:
If using 5 or 6g servos then you will need to adjust the servo mounting as
necessary to enable them to fit.
6
Install the flap servos in the same way as the aileron servos, but please note the difference when fitting the
flap control horns. These are installed in reverse to the normal direction, this is to allow you to achieve a
full 90° movement of the bottom hinged flaps for real slow flying and steep approaches.