H-KING Savage Bobber 1000 mm 5ch ARF Version, Инструкция по эксплуатации

Страница: 7 / 19

5
Dry fit the rudder/fin assembly onto the horizontal stabilizer, ensure they are perpendicular to each
other. Once you are satisfied with the fit, apply CA glue to the fin to secure it in place. Then install
hinges half way into the pre-slotted hinge pockets in the rudder by applying a small amount of
thin CA glue as shown, wait until it has throughly dried. Install the rudder to the fin, and slide
the hinges into the hinge pockets on the fin. Use a hobby knife to enlarge the hinge pocket if
needed to allow it to align properly. If the installation looks good, apply a small amount of thin CA
glue to secure it in place. Check frequently if it moves freely as glue sets.
Install the tail wheel onto the rudder landing gear wire and use the supplied wheel collar to lock it in
place. Apply a small amount of thread lock glue to the grub screws to prevent them from loosening
in flight.
At this point, reinforce the joint in the seam
between the stabilizer and the tail structure by
running in a thin layer of medium CA glue.
The empennage and the landing gear setup is
now complete.