Radio installation:
1
Use the supplied hook and loop
self-adhesive tape to secure your
chosen receiver to the inside
of
the
radio compartment. We recommend
that you now setup your radio and
the servo throws etc.
WARNING:
DO NOT INSTALL THE PROPELLER ONTO YOUR PLANE UNTIL THE RADIO SETUP HAS BEEN
COMPLETED. ALSO, ALWAYS TURN YOUR TX ON FIRST AND ENSURE THAT THE THROTTLE
STICK IS IN THE LOW POSITION BEFORE PLUGGING IN YOUR FLIGHT BATTERY TO THE
ESC. THEN WHEN YOU HAVE FINISHED FLYING OR SETTING UP ALWAYS UNPLUG THE
FLIGHT BATTERY FIRST BEFORE SWITCHING OFF YOUR TX.
NOTE:
For binding your radio, and for setting up the servo reverse, subtrims, and end point adjustments, etc,
please consult your R/C instruction manual.
1
2
3
4
5
Repeat this process for all the other control surfaces.
Switch on your TX, then connect your flight battery to the ESC power cable with the
XT60
connector.
Elevator control surfaces setup: First set the servo trimmer on your TX radio to
the
center
position.
Then loosen the stopper screw and ensure the servo horn is perpendicular to the
pushrod as
shown. Secondly, ensure that the elevator control surface is perfectly level. Apply a
drop of
Loctite glue to the thread of the stopper screw and hand tighten.
Finally, move the elevator control stick on your TX to check that it moves freely with no binding.
Once you are happy with this then set the end points to the recommended throws below.
7
