TX AND ORX STABILISATION
DEVICE SETUP
Note: If you wish to set up Expo/Dual rates on the elevator and aileron
channels to meet your flying style, you must set them only under the
Intermediate and Expert flight mode.
SWITCH ON THE TX
Place your F-1
8
50mm EDF on level ground. Plug in your battery flight pack and let
it sit still, during this time the plane is in auto self-calibration mode. The LED light on
the stabilization device will keep flashing rapidly for 3-6 secs, then the light will
remain solid. In the mean time the aileron,
and
elevator control surfaces will move
up/ down
,
and left/right 3 times to indicate the self-calibration is successful.
When the self calibration has been carried out the stabilization system is still
not in ready mode. Now check to see if all the control surfaces are in a
neutral position. If not, please adjust the push-rod clevises to ensure all the
control surfaces are neutral before flight, then cycle the battery power to
store this setup.
After all these setup procedure have been completed, plug in the battery once
again and wait until all the control surfaces move up/down and left/right 3
times to confirm the self- calibration before flight.
At this point the gyro is not in ready mode until you give the throttle a short
blip 10-15% in order to switch on the stabilization system. Check that the gyro
responds accordingly to the plane when being tilted up/down in pitch,
left/right in roll.
10
