LED I N DI CAT I ON ST AT U S
To arm the stabilization system you need to open the throttle to a low setting for 1
or 2 seconds then close the throttle. Now pick the model up and check to see if it is
in beginners mode or advanced mode. To do this move the nose up and down and
watch the elevator servo movement. If it's in beginners mode the servo will move
quite a bit, in advanced mode the servo will move less. Set the stabilization system
into beginners mode then check that it is working correctly by doing the following
test. Roll the aircraft to the right, the left aileron should go up, and the right down.
Roll the aircraft to the left, and the right aileron should go up, and the left down.
Move the nose down, and the elevator should go up, move the nose up, and the
elevator should go down. If all works correctly then you are ready to fly.
• LED light off (No radio signal)
• LED light turns solid (Beginner mode)
• LED light flashes quickly (Intermediate mode)
• LED light flashes slowly (Expert mode)
11
